led tubelight how to disassemble?
led tubelight is the application of new LED lighting source in the traditional down light on the basis of improved development of products, energy saving, low carbon, longevity, good color rendering, fast response speed are its advantages, but this lamp is also gradually used. Aisle living room meeting room and other places are very common, the ceiling is more suitable for the suspended ceiling, so how to remove led tubelight? If it's broken, you need to do this step, so let's take a look at it.
led tubelight how to disassemble?
The method is very simple. A downlight is a type of light fixture embedded in the ceiling. There is a spring buckle on each side, you can just take it off. Downlights are generally lamps with a screw cap that can be fitted directly to incandescent or CFLS. led tubelight used for a long time, there is a failure at this time should be how to replace the maintenance?
1,Prepare led tubelight replacement and maintenance tools required, general replacement and maintenance of led tubelight common tools are: electric tape, the same type of led tubelight set, pliers, if necessary, also need a small hand saw.
2,Turn off the power and slowly buckle the lamp, pay attention to the spring clip on the lamp, and press down with your finger to take the lamp. If you do not pay attention to the spring clip, you will be injured by the spring clip when pulling the lamp head straight down, so be careful to remove the old bad led tubelight.
3,then first disassemble the connector, replace the lamp cap, the driver does not move, open the light switch if the light is not bright can be sure that the driver is faulty, replace the driver.
4,at this time to turn off the light switch is the best to turn off the total power supply, and then the drive power into the line is removed (directly cut short can also be), then take off the bad drive and then the new drive power input segment peel, two lamp wire peeling.
5,Let one of the drive power cables be wrapped around one of the lamp power cables (lighting is not positive or negative), and then stick with electrical tape. The other one is also connected and wrapped with electrical tape.
6,to be completed, the next power experiment, turn on the light on, if not, repeat the above steps but not to replace the driver but directly replace the led tubelight.
If the LED power supply is damaged, go to buy the power supply with the same parameters such as voltage and current, and replace it. If there are a lot of damaged LED lights, and the damaged LED patch lights are concentrated in the same area, you can cut off the damaged part and weld it again.
If you have some basic knowledge of electronics, buy the same type of LED light, grab a soldering iron, and re-solder it. But then again, each LED strip has a lot of LED patch light components, one or two bad, no effect on the brightness.
The above is how to dismantle the led tubelight knowledge introduction, I believe you should have more understanding after reading it, the content is only for your reference, I hope to help you.
led tubelight common use places
Is led tubelight or LED spot light suitable for the restaurant?
